Release Notes

 Rename the keystore.db.bak at /opt/dell/srvadmin/lib/openmanage/apache-
tomcat/conf to keystore.db
o For 64-bit OS
 Delete the keystore.db file at /opt/dell/srvadmin/lib64/openmanage/apache-
tomcat/conf
 Rename the keystore.db.bak at
 /opt/dell/srvadmin/lib64/openmanage/apache-tomcat/conf to keystore.db
3. Start the Web server.
• BITS078118: On 12
th
generation of PowerEdge servers with specific versions of iDRAC, you cannot
set the platform event alert actions (reboot, shut down, and so on) through Server Administrator.
Set the alert actions for the events through iDRAC GUI.
• BITS130401: On 12
th
generation of PowerEdge servers, you cannot set the BIOS setup password
from the GUI. Use the CLI to set the password
• BITS144583: On Mozilla Firefox 21 or later, the "Quit browser" option does not work after logging
out from Server Administrator. To close the browser or tab, you must manually close the Firefox
browser tab.
• BITS177670: On Chrome 38 or later, the "Quit browser" option does not work after logging out from
Server Administrator. To close the browser or tab, you must manually close the Firefox browser tab.
• On PowerEdge T430, C4130, and R220 II, with PERC S130 configuration and no backplane,
Storage Management displays a mock backplane which does not support the blink/unblink
operation for disks available on this configuration.
Issures for Remote Access
NOTE: The Remote Access Service is supported on 11th generation of PowerEdge servers only. The
following subsections list the currently known issues regarding implementation and operation of your
RAC and the Remote Access Service in Server Administrator.
Limitations of Server Administrator on all Operating Systems
• The Server Administrator user interface and commands related to "local authentication enable" are
not applicable for RAC firmware 3.20. The Active Directory authentication feature replaces the
"local operating system authentication" feature in this version of firmware. Due to this change, the
following commands return errors:
"racadm localauthenable"
"omconfig rac authentication"
• Due to fluctuations in the watchdog timer, the "Last Crash Screen" may not be captured when the
Automatic System Recovery is set to a value of less than 30 seconds. To ensure the correct
functioning of the "Last Crash Screen" feature, set the System Reset Timer to at least 30 seconds.
• DF132894: The cfgDNSServer1 and cfgDNSServer2 properties of group cfgLanNetworking may be
set to identical values while swapping addresses. Some performance may be lost temporarily
during the swapping. The cfgLanNetworking group is configured using the "racadm config"
command.
• The remote access controller uses FTP protocol to perform some of the Server Administrator
commands. If a firewall is installed in the system, it may cause these commands to fail.
The following Server Administrator CLI commands use FTP protocol to communicate with the
RAC:
o
" omconfig rac uploadcert"
o "omconfig rac generatecert"
The following racadm commands use FTP protocol to communicate with the RAC: