Release Notes

enclosures. This limitation is a platform independent issue and can be observed on all supported
operating systems.
BITS131627: While resetting the temperature using the “Set Temperature Probe Wizard" option,
Storage Management is not able to reset the Warning threshold temperature of all the probes to
the default values. This is a platform independent issue and observed on all supported operating
systems. This issue also occurs for users performing this task through CLI.
BITS170356: Storage Management does not allow the user to reset the Warning threshold
temperature of all the probes to the default values as Storage Management detects the same
Warning and Failure threshold values for EMM Temperature Probe on all enclosures. This is a
platform independent issue and observed on all supported operating systems.
BITS165925: Reconfiguration is not supported for non-linear VDs. However, Storage Management
may provide this option to the users. After the user selects the reconfiguration option, Storage
Management displays the Minimum size value greater than the Maximum size value. This is a
known issue.
BITS191068: omreport storage does not contain description of the nvmeadapter command.
'omreport storage nvmeadapter -? command does not display any description. For more
information, see the Dell OpenManage Server Administrator <Version> Command Line Interface
Guide available at dell.com/openmanagemanuals.
Installation Prerequisites
Storage Management does not display controllers and their features on systems that do not meet the
driver and firmware requirements. At Storage Management runtime, you can determine whether the
system meets the firmware requirement or not, by checking the application log files for notifications on
outdated firmware. At runtime, On SCSI controllers, Storage Management displays the firmware version at
runtime while on SAS controllers it displays the firmware and driver versions.
Installation Procedure
For complete installation instructions, see the "Server Administrator version 8.1 Installation Guide".
This section provides information to enhance your experience with Server Administrator implementations
and environments.
To install Server Administrator on Windows Server 2008 R2 SP1 Core and Windows Server 2012
Core, Windows-on-Windows (WOW) mode must be enabled.
Port 1311 is the default port for Server Administrator. It is a registered port number of Server
Administrator. If another application is configured to run on port 1311 before Server Administrator
is installed, the DSM SA Connection Service does not start after installation. Before you install Server
Administrator, make sure that the port 1311 is not in use.
Before starting Server Administrator, you must enable the client-side scripting in Internet Explorer.
To do so, perform the following:
1. In Internet Explorer, navigate to the "Tools" menu.
2. Click "Internet Options".
3. Click the "Security" tab.
4. Select the security zone to which the system running Server Administrator belongs.
NOTE: This option should be set to "Trusted sites".
5. Click the "Custom Level" button.
6. For Windows 2003, perform the following:
(a) In "Miscellaneous", select the "Allow META REFRESH" radio button.
(b) In "Active Scripting", select the "Enable" radio button.
(c) Under "Active scripting", select the "Allow scripting of Microsoft web browser
controls" radio button.
7. Click "OK" and restart your browser.