Users Guide

Omconfig controller commands
The following table provides the omconfig command syntax required to execute controller tasks.
CAUTION: The omconfig storage controller action=resetconfig controller=id resets the
controller configuration. Resetting the controller configuration permanently destroys all data on
all virtual disks attached to the controller. System or boot partition residing on these virtual disks
is destroyed.
NOTE: If the PERC hardware controller is running in HBA mode, you can perform only one action,
exporting the log (action=exportlog).
Table 85. Omconfig Controller Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs
omconfig storage
controller
action=rescan controller=id
action=enablealarm controller=id
action=disablealarm controller=id
action=quietalarm controller=id
action=testalarm controller=id
action=resetconfig controller=id [force=yes]
action=createvdisk controller=id raid=<c | r0 | r1| r1c | r5 | r6 | r10 | r50 |
r60> size=<number | b | m | g | max | min> pdisk=<PDISKID> [stripesize=<
2kb | 4kb | 8kb | 16kb | 32kb | 64kb | 128kb | 256kb | 512kb | 1mb >]
[cachepolicy=<d | c>] [readpolicy=<ra | nra | ara | rc | nrc>]
[writepolicy=<wb | wt | wc | nwc | fwb>] [diskcachepolicy=<disabled |
enabled>] [name=<string>] [spanlength=<n>] | [secureflag=yes]
[vdpienabled=yes]
NOTE: For RAID 10 on SAS controllers with firmware version 6.1 and
later, spanlength is an optional parameter (default=2).
action=setrebuildrate controller=id rate=<0 to 100>
action=setchangecontrollerproperties controller=<id> [bgirate=<rate>]
[reconstructrate=<rate>][checkconsistencyrate=<rate>]
[rebuildrate=<rate>][clearredundantpath=clear]
[abortcheckconsistencyonerror=<enabled/disabled>][loadbalance=<auto/
disabled>][allowrevertiblehotspareandreplacemember=enabled/disabled]
[autoreplacememberonpredictivefailure=<enabled/disabled>]
[persistenthotspare=enabled/disabled]rate=<0 to 100>
action=discardpreservedcache controller=id force=<enabled/disabled>
action=createsecuritykey controller=id keyid=<keyid>
passphrase=<passphrase string> [escrow=yes] [filepath=<Absolute path to
the escrow file>]
176