Users Guide

– 4KN SAS drives

– Hot plug support on PERC S130 software RAID controller

– Changing the controller mode from RAID to HBA and vice versa on PERC 9 family of hardware

controllers. For more details see, omconfig Set Controller Mode.

– Samsung NVMe drives on VMware ESXi 6.0 operating system

• Support for 6Gbps SATA drive

NOTE: For the list of supported operating systems and Dell servers, see the Dell Systems Software

Support Matrix in the required version of OpenManage Software at dell.com/openmanagemanuals.

NOTE: CLI commands are not supported on systems running the VMware ESXi operating system.

Systems running the VMware ESXi operating system support only the Distributed Web Server (DWS)

interface.

Accessing the windows command prompt to run CLI

commands

If you are running the Microsoft Windows operating system, use the 32-bit command prompt to run a

Server Administrator CLI command. Access the 32-bit command prompt using one of the following

methods:

• Click Start → Programs → Accessories → Command Prompt.

• Click Start → Run and type cmd.exe.

NOTE: Do not type command in the Run dialog box to launch a command line window; this

activates the MS-DOS emulator command.com, which has environment variable limitations that

can cause subtle problems with CLI.

Primary CLI Commands

The commands that carry out the functions of Server Administrator are:

• omconfig

• omhelp

• omreport

The omconfig command writes values that you assign to an object's properties. You can specify values

for warning thresholds on components or prescribe actions that the system must perform when a certain

warning or failure event occurs. You can also use the omconfig command to assign specific values to the

system's asset information parameters, such as the purchase price of the system, the system's asset tag,

or the system's location.

The omhelp command displays short-text help for CLI commands. The shorthand equivalent of omhelp

is the command for which you want help followed by -?. For example, to display help for the omreport

command, type one of the following commands:

• omhelp omreport

• omreport -?

The omreport command displays reports of the management information of the system.