Glossary

Table 15. Controller Properties
Property Definition
Status These icons represent the severity or health of the storage component.
For more information, see Storage Component Severity.
• — Normal/OK
• — Warning/Non-critical
• — Critical/Failure/Error
ID Displays the ID assigned to the controller by Storage Management.
Storage Management numbers the controllers attached to the system
starting with zero. This number is the same as the controller ID
number reported by the omreport CLI Command. For information on
Command Line Interface, see the Server Administrator Command Line
Interface User’s Guide.
Name Displays the name of the controller.
State Displays the status of the controller. Possible values are:
• Ready — The controller is functioning normally.
• Degraded — The controller has encountered a failure and is
operating in a degraded state.
• Failed — The controller has encountered a failure and is no longer
functioning.
Firmware Version Displays the version of the firmware that is installed on the controller.
NOTE: Storage Management displays Not Applicable on some
controllers for which the firmware version cannot be obtained.
Minimum Required Firmware
Version
Displays the minimum firmware version that is required by Storage
Management. This property is displayed only if the controller firmware
does not meet the minimum requirement.
Driver Version Displays the version of the driver that is installed on the controller.
NOTE: Storage Management displays Not Applicable on some
controllers for which the driver version cannot be obtained.
Minimum Required Driver
Version
Displays the minimum driver version that is required by Storage
Management. This property is displayed only if the controller driver
does not meet the minimum requirement.
Number of Connectors Displays the number of connectors on the controller. Each connector
can be attached to physical disks or an enclosure. Depending on the
controller type, the connector can be either a SCSI channel or a SAS
port.
67