Reference Guide

name=value pair 1 name=value pair 2 Description
led=hdfault action=clear Sets the number of faults for the hard drive
back to zero (0).
led=identify flash=off | on time-out=<n> Sets the chassis identification LED to off or on.
Set the time-out value for the LED to flash to a
number of seconds.
Omconfig Chassis Remoteaccess Or Omconfig Mainsystem Remoteaccess
Use the omconfig chassis remoteaccess or omconfig mainsystem remoteaccesscommand to configure:
• Remote access on a local area network (LAN).
• The serial port for BMC or RAC, whichever is installed.
• The BMC or RAC on a serial over LAN connection.
• Terminal settings for the serial port.
• Advanced settings for a serial over LAN connection.
• Information on a BMC or RAC user.
• Information on IPv6 and IPv4 interfaces.
NOTE: Enter the user ID to configure user information.
Type:
omconfig chassis remoteaccess
or
omconfig mainsystem remoteaccess
The output of the omconfig chassis remoteaccess or omconfig mainsystem remoteaccess command
lists each of the available configurations. The following table displays the valid parameters:
Table 25. Valid Parameters Of Omconfig Chassis Remoteaccess Or Omconfig Mainsystem Remoteaccess
name=value pair 1
config=
name=value pair 2 Description
config=additional ipv4=enable | disable
enable: IPv4 stack to load on iDRAC.
disable: IPv4 stack to flush on iDRAC.
ipv6=enable | disable
enable: Enables IPv6 stack to load on iDRAC.
disable: Disables IPv6 stack to unload on
iDRAC.
NOTE: This option requires license to
enable or disable ipv6. If the appropriate
license is not installed or has expired, the
system displays an error message. For
more information, see Dell License
Manager at dell.com/
openmanagemanuals.
74