Reference Guide

– Displaying System Management Engine version and UEFI compliance version

• Support for the following in the Memory Settings group:

– Configuring cluster on die and snoop mode

• Support for the following in the Processor Settings group:

– Configuring the QpiSpeed to9.6 GT/s

– Configuring Address Translation Services (ATS)

– Configuring the number of cores per processor to 16 or 18

– Configuring the Dell Controlled Turbo as Custom

– Configuring Processor Controlled Turbo, Configurable TDP, and X2Apic mode feature

• Support for the following in the SATA Settings group:

– Configuring security freeze lock

• Support for the following in the Boot Settings group:

– Configuring the hard-disk drive failover

– Displaying the FQDDs in the legacy HDD list and boot order list

• Addition of the Network Settings, for configuring the PXE devices.

• Support for the following in Integrated Devices group:

– Configuring the USB 3.0 port

– Configuring internal SD primary card

– Configuring embedded video controller

– Configuring the current state of the embedded video controller

• Support for the following in the Serial Communication group:

– Configuring the serial communication as Auto

• Support for the following in the System Profile group:

– Configuring the system memory frequency to 1866MHz or 2133MHz

– Configuring energy efficient turbo

– Configuring the number of turbo boost enabled cores for a processor

– Configuring the processor uncore frequency

• Support for the following in the System Security group:

– Configuring TPM information and TPM command

– Configuring secure boot and secure boot policy

• Support for the following in the Miscellaneous group:

– Configuring Legacy Video Option ROM

NOTE: If you have configured the setup password, then, always set the same when you configure

any BIOS settings.