Reference Guide

Controller=id
Specify the controller ID as reported by the omreport storage controller command. For example,
controller=2
Raid=<c | r0 | r1 | r1c | r5 | r6 | r10 | r50 | r60>
Use the raid=<c| r0 | r1| r1c | r5 | r6 | r10 | r50 | r60> parameter to specify concatenation or a RAID level
for a virtual disk. Different controllers support different RAID levels. For more information about RAID
levels a controller supports and for general information about RAID levels and concatenation, see the Dell
OpenManage Online Help. The following table displays how to specify the raid=n parameter for each
RAID level and concatenation.
Table 93. Raid Level And Concatenation
RAID Level or Concatenation raid=n Parameter Specification
RAID-0 raid=r0
RAID-1 raid=r1
RAID-5 raid=r5
RAID-6 raid=r6
RAID-10 raid=r10
RAID-50 raid=r50
RAID-60 raid=r60
RAID-1-concatenated raid=r1c
Concatenation raid=c
size=<number | max | min> Parameter
The following table displays how to specify the size=<number | max | min>
Table 94. Size Parameter
size=<number | max | min> Parameter
Specification
Description
size=<n> Use this specification to indicate a specific size for
the virtual disk. The virtual disk size is specified in b
(bytes), m (megabytes), or g (gigabytes). For
example, size=500m indicates that the virtual disk
is 500 MB.
size=max To create a virtual disk that is the maximum size
possible, specify size=max. When creating a
RAID-50 virtual disk, this parameter is specified as
size=max.
size=min To create a virtual disk that is the minimum size
possible, specify size=min.
156