User's Manual

Property Definition

• — Critical/Failure/Error

ID Displays the ID assigned to the controller by Storage Management.

Storage Management numbers the controllers attached to the system

starting with zero. This number is the same as the controller ID

number reported by the omreport CLI Command. For information on

Command Line Interface, see the Server Administrator Command Line

Interface User’s Guide.

Name Displays the name of the controller.

State Displays the status of the controller. Possible values are:

• Ready — The controller is functioning normally.

• Degraded — The controller has encountered a failure and is

operating in a degraded state.

• Failed — The controller has encountered a failure and is no longer

functioning.

Firmware Version Displays the version of the firmware that is installed on the controller.

NOTE: Storage Management displays Not Applicable on some

controllers for which the firmware version cannot be obtained.

Minimum Required Firmware

Version

Displays the minimum firmware version that is required by Storage

Management. This property is displayed only if the controller firmware

does not meet the minimum requirement.

Driver Version Displays the version of the driver that is installed on the controller.

NOTE: Storage Management displays Not Applicable on some

controllers for which the driver version cannot be obtained.

Minimum Required Driver

Version

Displays the minimum driver version that is required by Storage

Management. This property is displayed only if the controller driver

does not meet the minimum requirement.

Number of Connectors Displays the number of connectors on the controller. Each connector

can be attached to physical disks or an enclosure. Depending on the

controller type, the connector can be either a SCSI channel or a SAS

port.

Rebuild Rate Rebuild rate is the percentage of resources available on a system

dedicated to rebuild a failed disk when necessary. For more

information on rebuild rate, see Setting The Rebuild Rate.

NOTE: The value for the Revertible Hot Spare operation is the

same as the value set for the Rebuild Rate property.

BGI Rate The background initialization (BGI) rate is the percentage of resources

available on a system dedicated to perform the background