User's Manual

7. Click Execute.

Enclosure — Available Tasks

The drop-down menu enclosure tasks are:

• Enabling The Enclosure Alarm

• Disabling The Enclosure Alarm

• Setting Asset Data

• Blinking The LED On The Enclosure

• Setting The Temperature Probe Values

Enabling The Enclosure Alarm

Does my enclosure support this feature? See Supported Features.

Select the Enable Alarm task to enable the enclosure alarm. When enabled, the alarm turns on when any

of the following events occur:

• Enclosure temperature has exceeded the warning threshold.

• Power supply, fan, or enclosure management module — EMM has failed.

• Split bus is not installed. A split bus is indicated by a single triangle symbol on the back of the

enclosure.

Related Links

Using Alarms To Detect Failures

Disabling The Enclosure Alarm

Does my enclosure support this feature? See Supported Features.

Select the Disable Alarm task to disable the enclosure alarm. The alarm is turned off when the enclosure

exceeds a warning threshold for temperature or experiences other error conditions such as a failed fan,

power supply, or controller. If the alarm is already turned on, you can turn it off with this task.

Setting Asset Data

Does my enclosure support this feature? See Supported Features.

You can change the asset tag and asset name of the enclosure. The new asset tag and asset name that

you specify are displayed on the Information/Configuration of the enclosure.

Changing The Asset Tag And Asset Name Of An Enclosure

To change the asset tag and asset name of the enclosure:

1. Type the new asset tag name in the New asset tag field.

You can specify an inventory number or other useful information for your environment. The asset tag

typically refers to the enclosure hardware.

2. Type the new asset name in the New asset name field.

You can specify a name useful to you for organizing your storage environment. For example, the

asset name could refer to the type of data stored on the enclosure or to the enclosure’s location.

3. Click Apply Changes.

To exit and cancel your changes, click Go Back To Enclosure Information Page.