SNMP Reference Guide

Description Line Item Explanation
Memory device bank
location: <Bank name
in chassis>
Specifies the name of the memory bank in the system that generated
the message, for example:
Memory device bank location: Bank_1
Memory device
location: <Device name
in chassis>
Specifies the location of the memory module in the chassis, for
example:
Memory device location: DIMM_A
Number of devices
required for full
redundancy: <Number>
Specifies the number of power supply or cooling devices required to
achieve full redundancy, for example:
Number of devices required for full redundancy: 4
Peak value (in Watts):
<Reading>
Specifies the peak value in Watts, for example:
Peak value (in Watts): 125
Possible memory module
event cause: <list of
causes>
Specifies a list of possible causes for the memory module event, for
example:
Possible memory module event cause: Single bit warning
error rate exceeded
Single bit error logging disabled
Power Supply type:
<type of power supply>
Specifies the type of power supply, for example:
Power Supply type: VRM
Pre-failure state was:
<State>
Specifies the status of the previous memory message, for example:
Pre-failure state was: Failed
Previous redundancy
state was: <State>
Specifies the status of the previous redundancy message, for example:
Previous redundancy state was: Lost
Previous state was:
<State>
Specifies the previous state of the sensor, for example:
Previous state was: OK (Normal)
Processor sensor
status: <status>
Specifies the status of the processor sensor, for example:
Processor sensor status: Configuration error
Redundancy unit:
<Redundancy location
in chassis>
Specifies the location of the redundant power supply or cooling unit in
the chassis, for example:
Redundancy unit: Fan Enclosure
SD card device type:
<Type of SD card
device>
Specifies the type of SD card device, for example:
SD card device type: Hypervisor
SD card state: <State
of SD card>
Specifies the state of the SD card, for example:
SD card state: Present, Failed
Sensor location:
<Location in chassis>
Specifies the location of the sensor in the specified chassis, for example:
Sensor location: CPU1
Temperature sensor
value (in degrees
Celsius): <Reading>
Specifies the temperature in degrees Celsius, for example:
Temperature sensor value (in degrees Celsius): 30
Voltage sensor value
(in Volts): <Reading>
Specifies the voltage sensor value in volts, for example:
Voltage sensor value: 1.693
505