Release Notes

• DF330800: Server Administrator Web server local user login fails on the Windows 2008 R2
Managed Node. When a Windows 2008 R2 Managed Node is added to a domain, logging
in from any Server Administrator Web Server to that Windows 2008 R2 Managed Node
will fail with local user or local power-user credentials. Only the credentials of a local
Administrator or Domain user will work, with a prerequisite that all required winrm
configurations have been applied.
Issues for Server Administrator running on Microsoft Windows 2012 Operating Systems
• BITS068231: On Windows Server 2012 with Server Administrator (32-bit), “Base Memory
Address” and IRQ values are not available for any Network Interface Cards.
Issues for Server Administrator running on Red Hat Enterprise Linux Operating Systems
• When starting Server Administrator from the Red Hat Enterprise Linux console, kernel
log messages may appear. To avoid these messages, perform the following steps:
• Edit the "/etc/sysconfig/syslog" file and modify KLOGD_OPTIONS to KLOGD_OPTIONS="-c
4".
• Restart "syslog" by executing "/etc/init.d/syslog restart".
• When using the Mozilla browser on Red Hat Enterprise Linux operating systems, the
font
and type size on the Server Administrator global navigation bar appear different
from the
default font and type size that application uses.
• For systems running a supported Red Hat Enterprise Linux operating system, kernel
driver
messages such as "AAC_ChardevOpen" may be displayed in the console at the
login
prompt. These messages are displayed in the console when the driver
initialization is
delayed by the installation of Server Administrator services and can be ignored.
• BITS110353: On servers installed on FX2 series chassis Server Administrator Home page
does not load on Red Hat Enterprise Linux 6.5 operating system.
Issues for Remote Access
NOTE: The Remote Access Service is supported on 11G systems only.
The following subsections list the currently known issues regarding implementation and operation of your RAC
and
the Remote Access Service in Server Administrator.
Issues for all Operating Systems
• Server Administrator user interface and commands related to "local authentication
enable"
are not applicable for RAC firmware 3.20. The Active Directory authentication
feature
replaces the "local operating system authentication" feature in this version of
firmware.
Due to this change, the following commands return errors:
"racadm localauthenable"
"omconfig rac authentication"
• Due to fluctuations in the watchdog timer, the "Last Crash Screen" may not be captured
when the Automatic System Recovery is set to a value of less than 30 seconds. To ensure
correct functioning of the "Last Crash Screen" feature, set the System Reset Timer to at
least 30 seconds.
• DF132894: The cfgDNSServer1 and cfgDNSServer2 properties of group cfgLanNetworking
may be set to identical values while swapping addresses. Some performance may be lost
temporarily during the swapping. The cfgLanNetworking group is configured using the
"racadm config" command.
• The remote access controller uses FTP protocol to perform some of the Server
Administrator commands. If a firewall is installed in the system, it may cause these
commands to fail.