Reference Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
attribute=hddorder sequence=aliasname1,
aliasname2,..... aliasnameN
Configures the BIOS setup hard
disk sequence according to the
set aliasnames. Changes takes
effect after rebooting the system.
To view the set alias names, run
the command omreport
chassis biossetup
attribute=bootorder
NOTE: On Linux systems,
user or user groups
upgraded to administrator or
administrator groups cannot
configure this BIOS setup
setting.
attribute=cstates setting=enabled | disabled
• enabled: Enables the
processor to go into a deep
sleep state when the system is
not utilized.
• disabled: Disables the
processor to go into a deep
sleep state when the system is
not utilized.
attribute=conredirect setting=enabled | disabled
• enabled: Redirects the BIOS
screen output over serial port
1. Keyboard and text output
are redirected over serial port
2.
• disabled: Turns off the BIOS
console redirection.
attribute=crab setting=enabled | disabled
• enabled: Enables BIOS
console redirection after
system reboot.
• disabled: Disables BIOS
console redirection.
NOTE: The attribute crab is
valid for Dell PowerEdge 9G
systems only.
attribute=cpucle setting=enabled | disabled
• enabled: Enables processor
C1-E after system reboot.
• disabled: Disables processor
C1-E after system reboot.
attribute=cpuht setting=enabled | disabled
• enabled: Enables logical
processor hyperthreading.
• disabled: Disables logical
processor hyperthreading.
attribute=cpuvt setting=enabled | disabled
• enabled: Enables
virtualization.
68