Reference Guide

Table 21. BIOS Setup Settings on systems prior to PowerEdge 12G systems
name=value pair 1 attribute= name=value pair 2 setting= Description
attribute=acpwrrecovery setting=off | last| on
• off: System is turned off.
• last: System returns to the
previous state.
• on: System is turned on.
delay=random | immediate |
timedelay <value>
• random: System is turned on
with random delay.
• immediate: System returns to
previous state immediately.
• timedelay <value>: System is
turned on based on the user
specified time delay.
attribute=bezel setting=enabled | disabled
• enabled: Enables the bezel
removal intrusion check
during system boot.
• disabled: Disables the bezel
removal intrusion check
during system boot.
attribute=bootsequence setting=diskettefirst | hdonly |
devicelist | cdromfirst |
opticaldrive
Instructs the BIOS which device is
used to boot the system, and the
order in which the boot routine
checks each device.
NOTE: On Linux systems,
user or user groups
upgraded to administrator or
administrator groups cannot
configure this BIOS setup
setting.
attribute=bootmode setting=uefi | bios
• uefi: Enables the system to
boot to operating systems
that support Unified
Extensible Firmware Interface
(UEFI).
• bios: Enables the system to
boot to operating systems
that do not support UEFI.
attribute=bootorder sequence=aliasname1,
aliasname2,..... aliasnameN
Configures the boot sequence
according to the set aliasnames.
To view the set alias names, run
the command omreport
chassis biossetup
attribute=bootorder
NOTE: On Linux systems,
user or user groups
upgraded to administrator or
administrator groups cannot
configure this BIOS setup
setting.
67