Reference Guide

Omreport Chassis Fru Or Omreport Mainsystem Fru
Use the omreport chassis fru or omreport mainsystem fru command to view FRU information. When you
type:
omreport chassis fru
or
omreport mainsystem fru
Server Administrator displays a summary of the system’s FRU information. This information is available in
the Server Administrator GUI, SNMP, and Common Information Model and is primarily used to support
troubleshooting activities.
Omreport Chassis Hwperformance Or Omreport Mainsystem
Hwperformance
Use the omreport chassis hwperformance or omreport mainsystem hwperformance command to view
the status and cause for the system’s performance degradation. When you type:
omreport chassis hwperformance
or
omreport chassis hwperformance
Server Administrator displays a summary of the system’s hardware performance degradation information.
NOTE: This command is applicable only to selected Dell 10G systems that support PMBus.
Depending on the system’s configuration, you may notice the following output:
Hardware Performance
Index : 0
Probe Name : System Board Power Optimized
Status : Normal
Cause : [N/A]
Omreport Chassis Info Or Omreport Mainsystem Info
Use the omreport chassis info or omreport mainsystem info command to see a summary of installed
component versions. Type:
omreport chassis info index=n
or
omreport mainsystem info index=n
The index parameter specifies a chassis number and is optional. If you do not specify the index, Server
Administrator displays summary chassis information for each chassis. If you specify the index, Server
Administrator displays summary information for a specific chassis.
NOTE: If iDRAC is installed, Server Administrator displays the Lifecycle Controller version. If BMC is
installed, Server Administrator displays the USC version.
31