Reference Guide

omconfig Change Controller Properties
Table 104. omconfig Change Controller Properties
Description
Changes any or all of the controller properties.
Syntax
omconfig storage controller action=
setchangecontrollerproperties
controller=<id> bgirate=<rate>
reconstructrate=<rate>
checkconsistencyrate=<rate>
rebuildrate=<rate>
clearredundantpath=clear
abortcheckconsistencyonerror=<enabled |
disabled> loadbalance=<auto | disabled>
allowrevertiblehotspareandreplacemember
=<enabled | disabled>
autoreplacememberonpredictivefailure=
<enabled | disabled>
persistenthotspare=<enabled | disabled>
Example to Enable allow revertible hot spare and replace
member operation.
Example
omconfig storage controller action=
setchangecontrollerproperties
allowrevertiblehotspare
andreplacemember=enabled controller=1
Omconfig Discard Preserved Cache
Descriptio
n
Discards the preserved cache on the controller.
NOTE: To check if the controller has a preserved cache, type omreport storage
controller controller=id. If the system displays Preserved Cache=yes, it
indicates the presence of the preserved cache.
Syntax
omconfig storage controller action= discardpreservedcache
controller=id force=enabled | disabled
If you set force=enabled, the cache is discarded irrespective of whether the controller
detects a foreign or an offline virtual disk.
Example
to
Discard the preserved cache.
Example
omconfig storage controller action= discardpreservedcache
controller=1 force=enabled
CAUTION: Discarding the preserved cache can result in data loss. It is recommended
that you run this command using the force=disabled option.
178