Reference Guide

Omconfig System Pedestinations Or Omconfig Servermodule Pedestinations
Use the omconfig system pedestinations or omconfig servermodule pedestinations command to set IP
addresses for alert destinations.
The following table displays the valid parameters for the command.
NOTE: You can either specify the index and IP address as parameters together or you can set only
the community string as a parameter.
NOTE: Index 1 to 4 accepts an IPv4 address and index 5 to 8 accepts an IPv6 address. On 12G
systems with iDRAC7 specific versions, the index can accept IPv4, IPv6, or FQDN.
Table 41. Valid Parameters Of Omconfig System Pedestinations Or Omconfig Servermodule Pedestinations
name=Value Pair Description
destenable=true | false
true: Enables an individual platform event filter destination after a valid IP
address has been set.
false: Disables an individual platform event filter.
index=number Sets the index for the destination.
ipaddress=<ipv4 address
| ipv6 address | fqdn>
Sets the IP address for the destination.
NOTE: On 12G systems with iDRAC7 specific versions, ipaddress can
also be a Fully Qualified Domain Name (FQDN).
communitystr=text Sets the text string that acts as a password and is used to authenticate SNMP
messages sent between the BMC and the destination management station.
Omconfig System Platformevents Or Omconfig Servermodule
Platformevents
Use the omconfig system platformevents or omconfig servermodule platformevents command to
configure shutdown action, if any, taken for a specific platform event. You can also enable or disable
platform event filter alert generation.
CAUTION: If you set a platform event shutdown action to anything other than none or power
reduction, the system is forcefully shutdown when the specified event occurs. This shutdown is
initiated by firmware and is carried out without first shutting down the operating system or any of
the applications running on your system.
The following table displays the valid parameters for the command.
NOTE: Alert settings are mutually exclusive and you can set one at a time only. The action settings
are also mutually exclusive and you can set one at a time only. However, alert and action settings
are not mutually exclusive of each other.
111