Command Line Interface Guide

name=value pair 1
config=
name=value pair 2 Description
vlanpriority=number
number: Priority of virtual LAN identification in
the range of 0 to 7.
privilegelevel=administrator |
operator | user
administrator: Sets the maximum privilege
level that is accepted on a LAN channel, to
Administrator.
operator: Sets the maximum privilege level
that is accepted on a LAN channel, to
Operator.
user: Sets the maximum privilege level that is
accepted on a LAN channel, to User.
encryptkey=text
confirmencryptkey=text
text: Text used for encryption and
confirmation of encryption.
NOTE: The text option is supported only
on PowerEdge 9G systems.
prefdnsserverv6=<value> Validates the preferred DNS server for
configuration.
config=serial baudrate=9600 | 19200 | 38400
| 57600 | 115200
9600: Sets the connection speed to 9600 bits
per second.
19200: Sets the connection speed to 19200
bits per second.
NOTE: Baud rates of 9600 and 19200 are
supported on PowerEdge 1800, 1850,
2800, and 2850 systems.
38400: Sets the volatile and non-volatile
connection speed to 38400 bits per second.
57600: Sets the volatile and non-volatile
connection speed to 57600 bits per second.
NOTE: Baud rates of 19200, 38400, and
57600 are supported on PowerEdge 9G
systems.
115200: Sets the volatile and non-volatile
connection speed to 115200 bits per second.
NOTE: Baud rate of 115200 is supported
on certain systems that have a DRAC 5
installed.
NOTE: Baud rate of 19200, 57600, and
115200 are supported on 10G systems that
have iDRAC installed.
flowcontrol=none | rtscts
none: No control over the flow of
communication through the serial port.
rtscts: RTS is ready to send and CTS is clear to
send.
mode=directbasic |
directterminal |
directbasicterminal |
directbasic: Type of messaging used for IPMI
messaging over a serial connection.
directterminal: Type of messaging that uses
printable ASCII characters and allows a limited
94