Command Line Interface Guide

name=value pair 1
config=
name=value pair 2 Description
NOTE: The failovernw option is supported
on PowerEdge12G systems onward.
Configure both primarynw and failovernw
to set the nicselection. The primarynw and
failovernw options cannot have the same
value.
NOTE: Failovernw requires license to
configure the ports. If the appropriate
license is not installed or has expired, the
system displays an error message. For
more information, see Dell License
Manager at dell.com/
openmanagemanuals.
ipaddress=IP
Sets the IP address if you have selected static
as the IP address source for the BMC LAN
interface.
subnet=Subnet Sets a subnet mask if you have selected static
as the IP address source for the BMC LAN
interface.
gateway=Gateway
Sets a gateway address if you have selected
static as the IP address source for the BMC LAN
interface.
ipsource=static | dhcp |
systemsoftware
static: Static if the IP address of the BMC LAN
interface is a fixed, assigned IP address.
dhcp: DHCP if the source of the IP address of
the BMC LAN interface is the dynamic host
configuration protocol.
systemsoftware: System software if the source
of the IP address of the BMC LAN interface is
from the system software.
NOTE: All commands may not be
supported on the system.
ipaddressv6=<IPv6 address>
prefixlength= length
Validates the IPv6 address for configuration.
gatewayv6=<value> Validates the IPv6 gateway.
ipsourcev6=static | auto
static: IPv6 address source is set to static.
auto: IPv6 address source is set to auto.
altdnsserverv6 Validates the address of the alternate DNS
server for configuration.
dnssourcev6=static | auto
static: DNS source is set to static.
auto: DNS source is set to auto.
vlanenable=true | false
true: Enables the virtual LAN identification.
false: Disables the virtual LAN identification.
vlanid=number
number: Virtual LAN identification in the range
of 1 to 4094.
93