Command Line Interface Guide

name=value pair 1
config=
name=value pair 2 Description
NOTE: The enablenic option is supported
on PowerEdge 9G systems that have
DRAC 5 installed.
nicselection=sharedwithfailover
onall | nic1 |teamednic1nic2 |
dracnic
sharedwithfailoveronall: Configures the new
NIC selection option.
nic1: Enables NIC 1.
teamednic1nic2: Enables NIC teaming
functionality.
dracnic: Enables DRAC NIC if DRAC 5 is
installed.
NOTE: The nicselection option is
supported only on PowerEdge 9G to 11G
systems. From PowerEdge 12G systems
onwards, primarynw and failovernw
replaces nicselection.
primarynw=dedicated | lom1 |
lom2 | lom3 | lom4
dedicated: Configures dedicated port as
primary network for remote access.
NOTE: This option requires license to
configure primarynw as dedicated. If the
appropriate license is not installed or has
expired, the system displays an error
message. For more information, see Dell
License Manager at dell.com/
openmanagemanuals.
lom 1: Configures lom1 port as the primary
network for remote access.
lom 2: Configures lom2 port as the primary
network for remote access.
lom 3: Configures lom3 port as the primary
network for remote access.
lom 4: Configures lom4 port as the primary
network for remote access.
NOTE: The primarynw option is supported
from PowerEdge12G systems onward. If
the primarynw is set to dedicated, then set
failovernw to none.
failovernw=none | lom1 | lom2 |
lom3 | lom4 | all
none: Configures the failover network to none.
lom 1:Configures the failover network to lom 1.
lom 2: Configures the failover network to lom
2.
lom 3: Configures the failover network to lom
3.
lom 4: Configures the failover network to lom
4.
all: Configures the failover network to all loms.
92