Command Line Interface Guide

name=value pair 1 attribute= name=value pair 2 setting= Description

NOTE: Depending on the

system's hardware you can

configure either usb or usbb.

attribute=cstates setting=enabled | disabled

• enabled: Enables the

processor to go into a deep

sleep state when the system is

not utilized.

• disabled: Disables the

processor from going into a

deep sleep state when the

system is not utilized.

BIOS Setup Settings On PowerEdge 12G systems

The following table lists the BIOS setup attributes supported on PowerEdge 12G systems. On PowerEdge

12G systems, the attributes are grouped. Based on the hardware configuration, the possible attributes

may vary in a specific group. The omconfig chassis biossetup command does not display the read-only

attributes.

NOTE: If you have configured the setup password, then, always set the same when you configure

any BIOS settings.

Table 22. BIOS Setup Settings On PowerEdge 12G Systems

Group name=value pair 1 attribute= name=value pair 2 setting=

BIOS Boot

Settings

attribute=BootSeq sequence=aliasname1, aliasname2,..... aliasnameN

attribute=HddSeq sequence=aliasname1, aliasname2,..... aliasnameN

Boot Settings attribute=BootMode setting=Bios | Uefi

attribute=BootSeqRetry setting=Enabled | Disabled

Embedded Server

Management

attribute=FrontLcd setting=None | UserDefined | ModelNum |

Advanced

attribute=UserLcdStr setting=<string>

Integrated

Devices

attribute=EmbVideo setting=Enabled | Disabled

attribute=IntegratedNetwork1 setting=Enabled | DisabledOs

attribute=IntegratedNetwork2 setting=Enabled | DisabledOs

attribute=IntegratedRaid setting=Enabled | Disabled

attribute=IntegratedSas setting=Enabled | Disabled

attribute=InternalSdCard setting=On | Off

attribute=InternalSdCardRedun

dancy

setting=Mirror | Disabled

attribute=InternalUsb setting=On | Off