Command Line Interface Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
• immediate: System returns to
previous state immediately.
• timedelay <value>: System is
turned on based on the user
specified time delay.
attribute=bezel setting=enabled | disabled
• enabled: Enables the bezel
removal intrusion check
during system boot.
• disabled: Disables the bezel
removal intrusion check
during system boot.
attribute=bootsequence setting=diskettefirst | hdonly |
devicelist | cdromfirst |
opticaldrive
Instructs the BIOS which device is
used to boot the system, and the
order in which the boot routine
checks each device.
NOTE: On Linux systems,
user or user groups
upgraded to administrator or
administrator groups cannot
configure this BIOS setup
setting.
attribute=bootmode setting=uefi | bios
• uefi: Enables the system to
boot to operating systems
that support Unified
Extensible Firmware Interface
(UEFI).
• bios: Enables the system to
boot to operating systems
that do not support UEFI.
attribute=bootorder sequence=aliasname1,
aliasname2,..... aliasnameN
Configures the boot sequence
according to the set aliasnames.
To view the set alias names, run
the command omreport
chassis biossetup
attribute=bootorder
NOTE: On Linux systems,
user or user groups
upgraded to administrator or
administrator groups cannot
configure this BIOS setup
setting.
attribute=hddorder sequence=aliasname1,
aliasname2,..... aliasnameN
Configures the BIOS setup hard
disk sequence according to the
set aliasnames. Changes takes
effect after rebooting the system.
To view the set alias names, run
the command omreport
chassis biossetup
attribute=bootorder
67