Command Line Interface Guide

Peak Reading : 2.5 A

NOTE: Power Management features are only available for PowerEdge systems that have hot-

swappable power supplies and not systems that have a fixed, non-redundant power supply installed.

Omreport Chassis Pwrsupplies Or Omreport Mainsystem Pwrsupplies

Use the omreport chassis pwrsupplies or omreport mainsystem pwrsupplies command to view properties

of the system’s power supplies. Type:

omreport chassis pwrsupplies

omreport mainsystem pwrsupplies

NOTE: To maintain consistency across the commands, the output format of this command has

changed. Change the user scripts as applicable.

For each power supply profile in the system, the values for the following fields are displayed:

• Status

• Location

• Type

• Rated Input Wattage (in Watts)

• Maximum Output Wattage

• Online Status

• Power Monitoring Capable

Omreport Chassis Remoteaccess Or Omreport Mainsystem Remoteaccess

Use the omreport chassis remoteaccess or omreport mainsystem remoteaccess command to view

general information on baseboard management controller or integrated Dell remote access controller

(BMC/iDRAC) and remote access controller if DRAC is installed. Type:

omreport chassis remoteaccess

omreport mainsystem remoteaccess

NOTE: To maintain consistency across the commands, the output format of this command and the

subsequent command levels has changed. So, you may have to change the user scripts as

applicable.

The output of the omreport chassis remoteaccess or omreport mainsystem remoteaccess command lists

each of the valid parameters as displayed in the following table:

Table 12. Valid Parameters Of Omreport Chassis Remoteaccess Or Omreport Mainsystem Remoteaccess

name=value pair Description

config=additional Reports the current state of IPv4 and IPv6 addresses on iDRAC.

config=advsol Reports advanced BMC/iDRAC or remote access information on a serial over local

area network (LAN) connection.

config=nic Reports BMC/iDRAC or remote access information for the LAN.