Command Line Interface Guide

Omconfig Convert Non-RAID To RAID
Description
Converts non-RAID to RAID on a physical disk.
Syntax
omconfig storage pdisk
action=convertnonraidtoraid
controller=id pdisk=<PDISKID>, where id is
the controller ID. The <PDISKID> variable specifies
the physical disk.
NOTE: To obtain these values, type omreport
storage controller to display the controller IDs
and then type omreport storage pdisk
controller=ID to display the IDs for the
physical disks attached to the controller.
NOTE: To convert multiple non-RAID to RAID
on a given controller, use omconfig storage
controller action=convertnonraidtoraid
command. For more information, see
omconfig Convert Multiple Non-RAID To
RAID.
Example to Convert non-RAID to RAID on physical disk 3 on
connector 0 of controller 1. On a SAS controller,
the physical disk resides in enclosure 2.
Example for SAS controllers
omconfig storage pdisk
action=nonraidtoraid controller=1
pdisk=0:2:3
Omconfig Virtual Disk Commands
The following table provides the omconfig command syntax required to execute virtual disk tasks.
CAUTION: The omconfig storage vdisk action=deletevdisk controller=id vdisk=id command
deletes a virtual disk. Deleting a virtual disk destroys all information including file systems and
volumes residing on the virtual disk.
Table 87. Omconfig Manage Virtual Disk Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs
omconfig storage vdisk action=checkconsistency controller=id vdisk=id
action=cancelcheckconsistency controller=id vdisk=id
action=pausecheckconsistency controller=id vdisk=id
action=resumecheckconsistency controller=id vdisk=id
action=checkconsistency controller=id vdisk=id
action=blink controller=id vdisk=id
action=unblink controller=id vdisk=id
action=initialize controller=id vdisk=id
153