Command Line Interface Guide

Table 82. omreport Fluid Cache Disk Command
Required Command Levels (1, 2, 3) And
name=value pair
Use
omreport storage fluidcachedisk
Displays the properties of the fluid cache disks.
Omreport Storage Tape
The following table describes the syntax for the omreport storage tape command.
Table 83. Omreport Storage Tape Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs Use
omreport storage tape Display tape drive properties.
controller=id, where id is the
controller number. For example:
controller=0.
Displays all tape drives.
connector=id Displays all the tape drives on the
specified connector.
tape=<tape id>, where
tapeid=id=<connector:targetID>
Displays the specified tape drive.
142