Command Line Interface Guide

Required Command Levels (1, 2,
3) and name=value pair
Optional name=value pairs Use
info=pwrsupplies index=n where
id is the controller number and
ENCLOSUREID is the enclosure
number and n is the number of a
power supply. For example:
controller=0 enclosure=2
info=pwrsupplies index=1
Omreport EMM Status
The following table describes the syntax for the omreport EMM commands
NOTE: The status of the EMMs is displayed as degraded if there is a mismatch between the EMM
firmware.
Table 72. Omreport EMM Commands
Required Command Levels (1, 2,
3) and name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for
all enclosures attached to the
system.
controller=id
enclosure=<ENCLOSUREID>
info=emms where id is the
controller number and
ENCLOSUREID is the enclosure
number. For example:
controller=0 enclosure=2
Displays the enclosure
management modules (EMMs)
for the specified enclosure.
controller=id
enclosure=<ENCLOSUREID>
info=emms index=n where id is
the controller number and
ENCLOSUREID is the enclosure
number and n is the number of
an EMM. For example:
controller=0 enclosure=2
info=emms index=1
Displays the specified EMMs.
Omreport Enclosure Slot Occupancy Report
The following table describes the syntax for the omreport Enclosure Slot Occupancy Report commands
138