Command Line Interface Guide

Table 70. Omreport Fan Status
Required Command Levels (1, 2,
3) and name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for
all enclosures attached to the
system.
controller=id
enclosure=<ENCLOSUREID>
info=fans where id is the
controller number and
ENCLOSUREID is the enclosure
number. For example:
controller=0 enclosure=2
NOTE: For SCSI controllers,
the ID specified in
enclosure=<ENCLOSUREID>
is the connector number and
for Serial Attached SCSI (SAS)
controllers, ID is the
connectorNumber:Enclosur
eIndex.
Displays the fans for the specified
enclosure.
controller=id
enclosure=<ENCLOSUREID>
info=fans index=n where id is the
controller number and
ENCLOSUREID is the enclosure
number and n is the number of a
fan. For example: controller=0
enclosure=2 info=fans index=1
Displays the specified fan.
Omreport Power Supply Status
The following table describes the syntax for the omreport Power Supply commands
Table 71. Omreport Power Supply Commands
Required Command Levels (1, 2,
3) and name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for
all enclosures attached to the
system.
controller=id
enclosure=<ENCLOSUREID>
info=pwrsupplies where id is the
controller number and
ENCLOSUREID is the enclosure
number. For example:
controller=0 enclosure=2
Displays the power supplies for
the specified enclosure.
controller=id
enclosure=<ENCLOSUREID>
Displays the specified power
supply.
137