Command Line Interface Guide

Command
Level 1
Command
Level 2
Command
Level 3
Use
fluidcachepool Displays fluid cache pool properties.
partition Displays the partition details of the specified virtual
disk.
fluidcachedisk Displays the fluid cache disk properties.
Omreport Physical Disk Status
The following table describes the syntax for the omreport Physical Disk commands.
Table 65. Omreport Physical Disk Commands
Required Command Levels (1, 2,
3) And name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id, where id is the
controller number. For example,
controller=0
Displays all physical disks
attached to the specified
controller.
NOTE: If a physical disk was
replaced by another disk as
part of the replace member
operation, the state of the
physical disk is displayed as
Replacing.
vdisk=id, where id is the virtual
disk number. For example,
vdisk=1
Displays all physical disks
included in the specified virtual
disk on the controller.
cachecade=id where id is the
cachecade number. For example,
cachecade=1
Displays all physical disks
included in the specified
cachecade on the controller.
connector=id where id is the
connector number. For example,
connector=1
Displays all physical disks
attached to the specified
connector on the controller.
pdisk=connectorID : targetID |
connectorID : enclosureID :
slotID, where
connectorID:targetID is the
connector number and the
physical disk number and
connectorID:enclosureID:slotID
is the connector number,
enclosure number, and slot
number. For example, pdisk=0:2
or pdisk=0:1:2
Displays the specified physical
disk on the specified connector
on the controller.
omreport Virtual Disk Status
The following table describes the syntax for the omreport Virtual Disk commands:
134