Command Line Interface Guide

In this example, the id in controller=idis the controller number such that controller 1 is specified as
controller=1.
Syntax Of Command Elements
The omreport and omconfig commands have multiple name=value pairs. These name=value pairs may
include required, optional, and variable parameters. The following table describes the syntax used to
indicate these parameters.
Table 63. Syntax For Name=Value Pairs
Syntax Description
controller=id
Indicates the controller ID as reported by the omreport
storage controller command. To obtain these values, type
omreport storage controller to display the controller
IDs and then type omreport storage pdisk
controller=id
to display the IDs for the physical disks
attached to the controller.
For example, the controller=id parameter is specified as
controller=1.
connector=id
Indicates the connector ID as reported by the omreport
command. To obtain this value, type omreport storage
controller to display the controller IDs and then type
omreport storage connector controller=id to
display the IDs for the connectors attached to the controller.
For example, the connector=id parameter is specified as
connector=2.
vdisk=id
Indicates the virtual disk ID as reported by the omreport
command. To obtain this value, type omreport storage
controller to display the controller IDs and then type
omreport storage vdisk controller=id to display the
IDs for the virtual disks on the controller.
For example, the vdisk=id parameter is specified as vdisk=3.
enclosure=<ENCLOSUREID>
Indicates a particular enclosure by specifying either
enclosure=connector or enclosure=connector:enclosureID.
To obtain these values, type omreport storage
controller to display the controller IDs and then type
omreport storage enclosure controller=id to
display the IDs for the enclosures attached to the controller.
pdisk=<PDISKID>
Indicates a particular physical disk by specifying either
connector:targetID or connector:enclosureID:targetID.
To obtain the values for the connector, enclosure, and
physical disk (targetID), type omreport storage
controller to display the controller IDs and then type
omreport storage pdisk controller=id to display the
IDs for the physical disks attached to the controller.
battery=id
Indicates the battery ID as reported by the omreport
command. To obtain this value, type omreport storage
controller to display the controller IDs and then type
omreport storage battery controller=id to display
the ID for the controller battery.
< >
The caret symbols (< >) enclose variable elements that you
must specify.
130