Release Notes

• BITS04016: In case of Boot/HDD/UEFI sequence, if they are read-only, then toggle buttons
(+ and -) and submit button are not visible. On BIOS setup page, dependencies may exist
between the various attributes for Bios settings. Setting an attribute value may change the
state of the dependent attributes to non-editable or editable. For example, changing the
Boot Mode to UEFI from the Boot Settings page does not allow you to configure the Boot
or Hard-Disk Drive Sequence in the BIOS Boot Settings page. When the page is non-
editable, the toggle buttons on the page allows toggling the order of the boot sequence.
However, settings cannot be configured since “Apply” button will not available to submit
the settings.
• BITS050574: On 11G and 12G systems running the Linux OS, the omreport system
summary command displays “RAC Command Interface” as 7.1.0. “RAC Command Interface”
is a DRAC4 RPM and its version is 7.1. It is installed as a dependent package for iDRAC6 and
iDRAC7 Command Interface packages.
• If a new certificate imported to Server Administrator is not active after restarting the Web
server, restore the previous certificate.
To restore the previous certificate, do the following:
1.
Stop the Web server.
2.
Perform one of the following as applicable:
On systems running Windows:
o Delete the file keystore.db at <installed directory>\Dell\SysMgt\apache-
tomcat\conf\
o Rename the file keystore.db.bak at <installed directory>\Dell\SysMgt\apache-
tomcat\conf\to keystore.db
On systems running Linux:
• For 32-bit OS
o Delete the keystore.db file at /opt/dell/srvadmin/lib/openmanage/apache-
tomcat/conf
o Rename the keystore.db.bak at /opt/dell/srvadmin/lib/openmanage/apache-
tomcat/conf to keystore.db
• For 64-bit OS
o Delete the keystore.db file at /opt/dell/srvadmin/lib64/openmanage/apache-
tomcat/conf
o Rename the keystore.db.bak at
/opt/dell/srvadmin/lib64/openmanage/apache-tomcat/conf to keystore.db
3. Start the Web server.
• BITS078118: On 12G systems with specific versions of iDRAC, you cannot set the platform
event alert actions (reboot, shut down, and so on) through Server Administrator. Set the
alert actions for the events through iDRAC GUI.
• BITS129426: On R220 systems with single CPU, Server Administrator does not display the
CPU status message on CLI and GUI.
• BITS130401: On 12G systems, you cannot set the BIOS setup password from the GUI. Use
the CLI to set the password.
Issues for Server Administrator Running on All Microsoft Windows Operating Systems
• Execute all Server Administrator CLI commands from a 32-bit Windows command prompt.
You can access the 32-bit command prompt by clicking "Start-> Programs-> Accessories->
Command Prompt" or by clicking "Start-> Run" and then typing "cmd.exe". Attempts to run
the CLI commands from the DOS command "command.com" may generate unpredictable
results.