Install Guide

Table 4. Deployment Scenarios(continued)

You want to Select

View the status of local and remote storage attached to a

managed system and obtain storage management information in an

integrated graphical view.

Storage Management.

Remotely access an inoperable system, receive alert notifications

when a system is down, and remotely restart a system.

DRAC Command Line Tools.

NOTE: Install the Simple Network Management Protocol (SNMP) agent on the managed system using the operating

system medium before installing the managed system software.

Installer Location

The location of the installers for 32–bit and 64–bit are:

• 32–bit: DVD Drive\SYSMGMT\srvadmin\windows\SystemsManagement\SysMgmt.msi

• 64–bit: DVD Drive\SYSMGMT\srvadmin\windows\SystemsManagementx64\SysMgmtx64.msi

NOTE: You cannot install both 32–bit and 64–bit installers on the same system.

Installing Server Administrator

This section explains how to install the Server Administrator and other managed system software using two installation options:

• Using the setup program at \SYSMGMT\srvadmin\windows on the Systems Management Tools and Documentation DVD.

• Using the unattended installation method through the Windows Installer Engine msiexec.exe.

NOTE:

SNMP service is stopped and started during Systems Management installation and uninstallation. As a result,

other third-party services, dependent on SNMP stop. If the third-party services are stopped, manually restart the

services.

NOTE: For Blade systems,install Server Administrator on each server module installed in the chassis.

NOTE: During installation of Server Administrator on supported Windows systems, if an Out of Memory error message

is displayed, exit the installation and free up memory. Close other applications or perform any other task that frees up

memory, before reattempting Server Administrator installation.

NOTE: If you use the MSI file to try to install Server Administrator on a system where the User Account Control settings

is set to a greater level, the installation fails and displays a message: Server Administrator installation

program could not install the HAPI driver. You must perform the installation process as an administrator.

You can also install Server Administrator successfully by the following methods:

• Click the setup.exe file, or

• Right-click Command Prompt > Run as administrator, and then run the installer command in CLI mode. For more

information on CLI mode, see Installing Managed System Software In CLI Mode

The setup program invokes the prerequisite checker, which uses the system's Peripheral Component Interconnect (PCI) bus to search for

installed hardware such as controller cards.

The Systems Management installer features a Typical Setup option and a Custom Setup option for installing Server Administrator and

other managed system software.