Reference Guide

Table 27. Valid Parameters Of Omconfig Chassis Memorymode Or Omconfig Mainsystem Memorymode
name=value pair 1 Description
index=< n > Number of the chassis where the memory module resides
(the default is chassis 0, the main system chassis).
redundancy=spare | mirror | disabled | raid5 | dddc
spare: Disables the memory module that has a correctable
memory event and copies the failing module’s data to a
spare bank.
mirror: Switches the systems to a mirrored copy of the
memory if the failing module has an uncorrectable
memory event. In the mirror mode, the operating system
does not switch back to the original module until the
system reboot.
disabled: Indicates that the system is not to use other
available memory modules if uncorrectable memory
events are detected.
raid5: Method of system memory configuration. This is
logically similar to the RAID-5 mode used in hard drive
storage systems. This memory mode provides an extra
level of memory checking and error recovery at the
expense of some memory capacity. The RAID mode
supported is RAID level 5 striping with rotational parity.
dddc: The dddc mode enables double device data
correction. This ensures data availability after hard failure
of x4 DRAM.
opmode=mirror | optimizer | advecc
mirror: Switches the systems to a mirrored copy of the
memory if the failing module has an uncorrectable
memory event. In the mirror mode, the operating system
does not switch back to the original module until the
system reboots.
optimizer: Enables the DRAM controllers to operate
independently in 64-bit mode and provide optimized
memory performance.
advanced ECC (advecc): Enables the two DRAM
controllers to combine in 128-bit mode and provide
optimized reliability. Memory that are not teamed by the
controllers is not reported to the operating system.
Omconfig Chassis Pwrmanagement Or Omconfig Mainsystem Pwrmanagement
Use the omconfig chassis pwrmanagement or omconfig mainsystem pwrmanagement command to configure power cap
and manage profiles that control power utilization.
NOTE: This command is valid only on systems prior to PowerEdge 12G systems.
The following table displays the valid parameters for the command:
Table 28. Valid Parameters Of Omconfig Chassis Pwrmanagement Or Omconfig Mainsystem Pwrmanagement
name=value pair 1 name=value pair 2 Description
config=budget cap=< value >
Sets the threshold value for power
budget.
81