Reference Guide

name=value pair 1 attribute= name=value pair 2 setting= Description

NOTE: Depending on the

system's hardware you can

configure either usb or usbb.

attribute=cstates setting=enabled | disabled

• enabled: Enables the processor to

go into a deep sleep state when

the system is not utilized.

• disabled: Disables the processor

from going into a deep sleep state

when the system is not utilized.

BIOS Setup Settings On PowerEdge 12G systems

The following table lists the BIOS setup attributes supported on PowerEdge 12G systems. On PowerEdge 12G systems,

the attributes are grouped. Based on the hardware configuration, the possible attributes may vary in a specific group.

The omconfig chassis biossetup command does not display the read-only attributes.

NOTE: If you have configured the setup password, then, always set the same when you configure any BIOS

settings.

Table 22. BIOS Setup Settings On PowerEdge 12G Systems

Group name=value pair 1 attribute= name=value pair 2 setting=

BIOS Boot Settings attribute=BootSeq sequence=aliasname1, aliasname2,..... aliasnameN

attribute=HddSeq sequence=aliasname1, aliasname2,..... aliasnameN

Boot Settings attribute=BootMode setting=Bios | Uefi

attribute=BootSeqRetry setting=Enabled | Disabled

Embedded Server

Management

attribute=FrontLcd setting=None | UserDefined | ModelNum | Advanced

attribute=UserLcdStr setting=<

string

Integrated Devices attribute=EmbVideo setting=Enabled | Disabled

attribute=IntegratedNetwork1 setting=Enabled | DisabledOs

attribute=IntegratedNetwork2 setting=Enabled | DisabledOs

attribute=IntegratedRaid setting=Enabled | Disabled

attribute=IntegratedSas setting=Enabled | Disabled

attribute=InternalSdCard setting=On | Off

attribute=InternalSdCardRedundanc

setting=Mirror | Disabled

attribute=InternalUsb setting=On | Off

attribute=InternalUsb1 setting=On | Off

attribute=InternalUsb2 setting=On | Off

attribute=IoatEngine setting=Enabled | Disabled