Reference Guide

Maximum Failure

Threshold

: 6000RPM

You can use a text editor to insert the time that each block of data was captured. In comparing the two snapshots for fan

probe 0, you can see that the second report shows several changes. The reading of fan RPM has increased by 621 RPM

but is still within normal range. Someone has raised the minimum warning threshold by 200 RPM and has decreased the

maximum warning threshold by 2000 RPM.

Selecting A Format For The CLI Command Output

You can specify a format for the CLI command results. The format determines how the command output is displayed. If

the command results are directed to a file, the format is captured by the file to which you write the command results.

The available formats include:

• List (lst)

• Semicolon-separated values (ssv)

• Table (tbl)

• Custom delimited format (cdv)

The syntax for the formatting option is:

For example, type:

omreport system summary -fmt tbl

omreport servermodule summary -fmt tbl

where -fmt tbl specifies table format.

You can combine the formatting option with the option to direct output to a file. For example, type:

omreport system summary -fmt tbl -outa summary.txt

omreport servermodule summary -fmt tbl -outa summary.txt

where -fmt tbl specifies table format and -outa specifies that you append the command results to a file named

summary.txt .

List (lst)

The default format is lst or list format. Use this format when you want to optimize output for simple readability. You need

to specify a format for the command output only if you want a format other than the lst format.

To see the following example command output in lst format, type:

omreport system summary

omreport servermodule summary

No special formatting option is required because list format is the default display format. The network data part of the

example system summary is displayed as follows:

--------------

Network Data

--------------

180