Reference Guide

Table 76. Omreport Battery Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage battery Displays all batteries present on all
controllers on the system (Some
controllers do not have batteries).
controller=id, where id is the
controller number. For example:
controller=0
Displays the battery on the specified
controller.
controller=id battery=id, where id is
the controller number. For example:
controller=0
Displays the specified battery.
Omreport Global Information
The following table describes the syntax for the omreport Global Information commands.
Table 77. Omreport Global Information Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage globalinfo
Displays whether smart thermal
shutdown is enabled or disabled. For
more information, see Omconfig Global
Enable Smart Thermal Shutdown.
Displays the hot spare protection
policy that you have set. For more
information on setting hot spare
protection policy, see the Dell
OpenManage Server Administrator
Storage Management User’s Guide at
dell.com/support/manuals.
Omreport Connector Status
The following table describes the syntax for the omreport Connector commands
Table 78. Omreport Connector Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage connector
Displays all connectors present on all
controllers on the system.
NOTE: This command works only
when the controller ID is specified.
controller=id, where id is the
controller number. For example:
controller=0
Displays the connectors on the specified
controller.
controller=id connector=id,
where id is the connector
number. For example,
connector=0
Displays the specified connector.
129