Reference Guide

Table 48. Valid Parameters Of Web Server Configuration
name=value pair Description
action=start Starts the Web server.
action=stop Stops the Web server.
action=restart Restarts the Web server.
Omconfig System Recovery Or Omconfig Servermodule Recovery
Use the omconfig system recovery or omconfig servermodule recovery command to set the action when the operating
system hangs or crashes. You can also set the number of seconds that must pass before the system is considered to
have a hung operating system. The following table lists the valid parameters for the command
NOTE: The upper and lower limits for the timer are dependent on the system model and configuration.
Table 49. Valid Parameters Of Omconfig System Recovery Or Omconfig Servermodule Recovery
name=value pair Description
action=none Takes no action when the operating system is hung or has crashed.
action=reboot Shuts down the operating system and initiates system startup, performing BIOS checks, and
reloading the operating system.
action=poweroff Turns off electrical power to the system.
action=powercycle Turns off electrical power to the system, pauses, turns the power on, and reboots the system.
Power cycling is useful when you want to re-initialize system components such as hard
drives.
timer=< n > Number of seconds that must pass before the system is considered to have a hung operating
system (from 20 seconds to 480 seconds).
Example Recovery Commands
To set the action on hung operating system detection to powercycle, type:
omconfig system recovery action=powercycle
or
omconfig servermodule recovery action=powercycle
To set the system to hang for 120 seconds, before a recovery action is initiated, type:
omconfig system recovery timer=120
or
omconfig servermodule recovery timer=120
Omconfig System Shutdown Or Omconfig Servermodule Shutdown
Use the omconfig system shutdown or omconfig servermodule shutdown command to determine the way in which the
system shuts down. During system shutdown, the default is to shut down the operating system before powering off the
system. Shutting down the operating system first closes down the file system before powering the system down. If you
do not want to shut down the operating system first, use the osfirst=false parameter. The following table displays the
valid parameters for the command.
106