Reference Guide

Event Name Description
event=redundegrad Sets action or enables or disables alert generation when the system fans and/or
power supplies become inoperative, resulting in less than full redundancy for
that component.
event=redunlost Sets action or enables or disables alert generation when the system fans and/or
power supplies become inoperative, resulting in a lost or a no redundant
components working condition for that component.
event=systempowerwarn Sets actions when a power consumption probe detects a warning value.
event=systempowerfail Sets actions when a power consumption probe detects a failure value.
event=tempwarn Sets action or enables or disables alert generation when a temperature probe
detects that the temperature is approaching the maximum high or low limits.
event=removableflashmediapresent Sets actions that Server Administrator performs when the system detects a
removable flash media.
event=removableflashmediawarn Sets actions that Server Administrator performs when a removable flash media
warning is displayed.
event=removableflashmediafail Sets actions that Server Administrator performs when a removable flash media
fails.
event=tempfail Sets action or enables or disables alert generation when a temperature probe
detects that the temperature is either too high or low for proper operation.
event=voltfail Sets action or enables or disables alert generation when a voltage probe detects
that the voltage is too low for proper operation.
event=intdualsdcardcritical Sets actions that Server Administrator performs when an internal dual SD card
critical event occurs.
event=intdualsdcardwarn Sets actions that Server Administrator performs when an internal dual SD card
warning is displayed.
event=intdualsdcardabsent Sets actions that Server Administrator performs when an internal dual SD card
is not available.
event=intdualsdcardredunlost Sets actions that Server Administrator performs when the redundancy of an
internal dual SD card is lost.
event=watchdogasr Enables or disables alert generation configured by the ASR when the system has
hung or is not responding.
Omconfig System Events Or Omconfig Servermodule Events
Use the omconfig system events or omconfig servermodule events command to enable and disable SNMP traps for the
components on your system.
NOTE: Not all event types are present on the system.
There are four parameters in the name=value pair component of the omconfig system events command:
• Source
• Type
103