Command Line Interface Guide

Table 29. Valid Parameters Of Omconfig Chassis Pwrmonitoring Or Omconfig Mainsystem Pwrmonitoring

name=value pair 1 name=value pair 2 Description

index=<

> NA Number of the probe or probe index

(must specify).

config=probe warnthresh=settodefault Sets the minimum and maximum

warning thresholds values to default.

warnthresh=<

> Sets a value for the warning

threshold.

unit=watt | btuphr

watt: Displays the unit in Watts.

btuphr: Displays the unit in BTU/hr.

config=resetreading type=energy | peakpower

energy: Resets the system energy

reading.

peakpower: Resets the system peak

power.

NOTE: This command is applicable only on selected Dell 10G systems that support PMBus.

NOTE: Power monitoring requires license to configure the power budget information. If the appropriate license is

not installed or has expired, the system displays an error message. For more information, see

Dell License

Manager

at dell.com/openmanagemanuals.

Default Warning Thresholds

NOTE: Sensor managing capabilities vary across systems.

To set both the upper and lower power consumption probe warning threshold values to the recommended default value,

type:

omconfig chassis pwrmonitoring config=probe index=0 warnthresh=settodefault

omconfig mainsystem pwrmonitoring config=probe index=0 warnthresh=settodefault

You cannot default one value and set another. If you default the minimum warning threshold value, you are also

selecting the default value for the maximum warning threshold value.

Specify A Value For Warning Thresholds

If you prefer to specify values for the power consumption probe warning thresholds, you must specify the number of the

probe you are configuring and the warning threshold value. Configure the values to display either in BTU/hr or Watts. In

the following example, the probe that is being configured is probe 4:

omconfig chassis pwrmonitoring config=probe index=4 warnthresh=325 unit=watt

omconfig mainsystem pwrmonitoring config=probe index=4 warnthresh=325

unit=btuphr

When you issue the command and the system sets the values you specify, the following message is displayed:

Power consumption probe warning threshold(s) set successfully.

Omconfig Chassis Remoteaccess Or Omconfig Mainsystem Remoteaccess

Use the omconfig chassis remoteaccess or omconfig mainsystem remoteaccesscommand to configure: