Command Line Interface Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
• enabled: Enables CPU Turbo
Mode.
• disabled: Disables CPU Turbo
Mode.
attribute=uausb setting=on | backonly | off
• on: Enables the user-
accessible USB port(s).
• backonly: Enables only the
user-accessible USB port(s)
located at the back of the
system.
• off: Disables the user-
accessible USB port(s).
attribute=usb setting=enabled | disabled
• enabled: Enables the USB
port(s).
• disabled: Disables the USB
port(s).
NOTE: Depending on the system's
hardware you can configure
either usb or usbb.
attribute=usbb setting=enabled | enabledwithbios |
disabled
• enabled: Enables the USB
port(s) during system boot,
without BIOS support.
• enabledwithbios: Enables the
USB port(s) during system
boot, with BIOS support.
• disabled: Disables the USB
port(s) during system boot.
NOTE: Depending on the system's
hardware you can configure
either usb or usbb.
attribute=cstates setting=enabled | disabled
• enabled: Enables the
processor to go into a deep
sleep state when the system
is not utilized.
• disabled: Disables the
processor from going into a
deep sleep state when the
system is not utilized.
BIOS Setup Settings On PowerEdge 12G systems
The following table lists the BIOS setup attributes supported on PowerEdge 12G systems. On PowerEdge 12G systems,
the attributes are grouped. Based on the hardware configuration, the possible attributes may vary in a specific group.
The omconfig chassis biossetup command does not display the read-only attributes.
NOTE: If you have configured the setup password, then, always set the same when you configure any BIOS
settings.
74