Command Line Interface Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot configure this
BIOS setup setting.
attribute=bootmode setting=uefi | bios
• uefi: Enables the system to
boot to operating systems that
support Unified Extensible
Firmware Interface (UEFI).
• bios: Enables the system to
boot to operating systems that
do not support UEFI.
attribute=bootorder sequence=aliasname1,
aliasname2,..... aliasnameN
Configures the boot sequence
according to the set aliasnames. To
view the set alias names, run the
command omreport chassis
biossetup
attribute=bootorder
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot configure this
BIOS setup setting.
attribute=hddorder sequence=aliasname1,
aliasname2,..... aliasnameN
Configures the BIOS setup hard disk
sequence according to the set
aliasnames. Changes takes effect
after rebooting the system. To view
the set alias names, run the command
omreport chassis
biossetup
attribute=bootorder
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot configure this
BIOS setup setting.
attribute=cstates setting=enabled | disabled
• enabled: Enables the
processor to go into a deep
sleep state when the system
is not utilized.
• disabled: Disables the
processor to go into a deep
sleep state when the system
is not utilized.
attribute=conredirect setting=enabled | disabled
• enabled: Redirects the BIOS
screen output over serial port
1. Keyboard and text output
are redirected over serial port
2.
• disabled: Turns off the BIOS
console redirection.
65