Command Line Interface Guide

Example to Convert multiple non-RAID to RAID on controller 0.
Example
omconfig storage controller action=convertnonraidtoraid
controller=0 pdisk=0:2:3
Omconfig Convert Multiple Non-RAID To RAID
Description Converts multiple non-RAID to RAID on the given controller.
Syntax
omconfig storage controller action=convertnonraidtoraid
controller=id pdisk=<PDISKID>, where id is the controller ID as reported by the
omreport storage controller command and PDISKID is specified as
pdisk=connector:enclosureID:targetID | connector:targetID.
Example to Convert multiple non-RAID to RAID on controller 0,
Example
omconfig storage controller action=convertnonraidtoraid
controller=0 pdisk=0:2:3
Omconfig Enclosure Commands
The following table provides the omconfig command syntax required to execute enclosure tasks.
Table 107. Omconfig Enclosure Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs
omconfig storage
enclosure
action=enablealarm controller=id enclosure=<ENCLOSUREID>
action=disablealarm controller=id enclosure=<ENCLOSUREID>
action=setassettag controller=id enclosure=<ENCLOSUREID> assettag=<string>
action=setassetname controller=id enclosure=<ENCLOSUREID> assetname=<string>
action=settempprobes controller=id enclosure=<ENCLOSUREID> index=id minwarn=n
maxwarn=n
action=resettempprobes controller=id enclosure=<ENCLOSUREID> index=id
action=setalltempprobes controller=id enclosure=<ENCLOSUREID> minwarn=n maxwarn=n
action=resetalltempprobes controller=id enclosure=<ENCLOSUREID> minwarn=n
maxwarn=n
action=blink controller=id enclosure=<ENCLOSUREID> minwarn=n maxwarn=n
Omconfig Enable Enclosure Alarm
Description Enables the enclosure alarm
Example to Enable the alarm on the enclosure attached to connector 2 on controller 1.
Example for SCSI, SATA,
and ATA controllers
omconfig storage enclosure action=enablealarm controller=1
enclosure=2
Example for SAS
controllers
omconfig storage enclosure action=enablealarm controller=1
enclosure=1:2
173