Command Line Interface Guide

Required Command Levels (1,
2, 3)
Optional name=value pairs
16kb | 32kb | 64kb | 128kb | 256kb | 512kb | 1mb >] [cachepolicy=<d | c>]
[readpolicy=<ra | nra | ara | rc | nrc>] [writepolicy=<wb | wt | wc | nwc | fwb>]
[diskcachepolicy=<disabled | enabled>] [name=<string>] [spanlength=<n>] |
[secureflag=yes]
NOTE: For RAID 10 on SAS controllers with firmware version 6.1 and later,
spanlength is an optional parameter (default=2).
action=setrebuildrate controller=id rate=<0 to 100>
action=setchangecontrollerproperties controller=<id> [bgirate=<rate>]
[reconstructrate=<rate>][checkconsistencyrate=<rate>][rebuildrate=<rate>]
[clearredundantpath=clear][abortcheckconsistencyonerror=<enabled/disabled>]
[loadbalance=<auto/disabled>]
[allowrevertibilehotspareandreplacemember=enabled/disabled]
[autoreplacememberonpredictivefailure=<enabled/disabled>]
[persistenthotspare=enabled/disabled]rate=<0 to 100>
action=discardpreservedcache controller=id force=<enabled/disabled>
action=createsecuritykey controller=id keyid=<keyid> passphrase=<passphrase
string> [escrow=yes] [filepath=<Absolute path to the escrow file>]
NOTE: If you set escrow=yes, specify the escrow file path.
action=changesecuritykey controller=id keyid=<keyid> passphrase=<passphrase
string> oldpassphrase=<oldpassphrase string> [escrow=yes] [filepath=<Absolute
path to the escrow file>]
NOTE: If you set escrow=yes, specify the escrow file path.
action=deletesecuritykey controller=id
action=setbgirate controller=id rate=<0 to 100 >
action=setreconstructrate controller=id rate=<0 to 100>
action=setcheckconsistencyrate controller=id rate=<0 to 100>
action=exportlog controller=id
action=importsecureforeignconfig controller=id passphrase=<passphrase for
imported foreign configuration>
action=importforeignconfig controller=id
action=importrecoverforeignconfig controller=id
action=clearforeignconfig controller=id
action=setpdiskpwrmanagement controller=id
spindownunconfigureddrives=<enabled/disabled> spindownhotspares=<enabled/
disabled> spindownconfigureddrives=<enabled/disabled> idlec=<enabled/disabled>
spindowntimeinterval=<30 to 1440>(minutes) spinupstarttime=<HH:MM:AM/PM>
spinuptimeinterval=<1 to 24>(hours)
NOTE: Specify spinupstarttime and spinuptimeinterval only when you set
spindownconfigureddrives=enabled.
action=setpatrolreadmode controller=id mode=<manual | auto | disable>
158