Command Line Interface Guide

Omconfig Format Virtual Disk
Description Formats a virtual disk.
Syntax omconfig storage vdisk action=format controller=id vdisk=id,
where id is the controller ID and virtual disk ID as reported by the omreport command.
NOTE: To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage vdisk controller=ID to display the IDs for
the virtual disks attached to the controller.
Example to Format virtual disk 4 on controller 1
Example
omconfig storage vdisk action=format controller=1 vdisk=4
Omconfig Reconfiguring Virtual Disks
Description Reconfigures a virtual disk to change the virtual disk’s RAID level or increase its size by
either adding physical disks or using the available free space. On some controllers, you can
also remove physical disks.
Syntax
omconfig storage vdisk action=reconfigure controller=id
vdisk=id raid=<c| r0| r1| r1c| r5| r6| r10> pdisk=<PDISK>
[size=<size> vdcapacityexpansion=yes sizeinpercent=<1 to
100>], where id is the controller ID and virtual disk ID as reported by the omreport
command.
NOTE: To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage vdisk controller=ID to display the IDs for
the virtual disks attached to the controller.
Example to Reconfigure virtual disk 4 to a size of 800 MB, use RAID-5 and physical disks 0 through 3 on
connector 0 of controller 1. On a SAS controller, the physical disks reside in enclosure 2.
Example for SCSI, SATA,
and ATA controllers
omconfig storage vdisk action=reconfigure controller=1
vdisk=4 raid=r5 size=800m pdisk=0:0,0:1,0:2,0:3
Example for SAS
controllers
omconfig storage vdisk action=reconfigure controller=1
vdisk=4 raid=r5 pdisk=0:2:0,0:2:1,0:2:2,0:2:3
Example to Increase the size of the virtual disk by 20 percent using the available free space, use
RAID-5 and physical disks 0 through 3 on connector 0 of controller 1. On a SAS controller,
the physical disks reside in enclosure 2.
Example
omconfig storage vdisk action=reconfigure controller=1
vdisk=4 raid=r5 pdisk=0:2:0,0:2:1,0:2:2,0:2:3
vdcapacityexpansion=yes sizeinpercent=20
NOTE: vdcapacityexpansion parameter is supported only on PERC H700 and PERC H800
controllers. If you set vdcapacityexpansion=yes, specify sizeinpercent. If you do not
set vdcapacityexpansion, specify size.
Omconfig Secure Virtual Disk
Description
Encrypts a virtual disk.
Syntax
omconfig storage vdisk action=securevd controller=id
vdisk=id, where id is the controller ID and virtual disk ID as reported by the omreport
command.
154