Command Line Interface Guide

controller=id pdisk=<PDISKID>, where id is
the controller ID. The <PDISKID> variable specifies the
physical disk.
NOTE: To obtain these values, type omreport storage
controller to display the controller IDs and then type
omreport storage pdisk controller=ID to display the
IDs for the physical disks attached to the controller.
NOTE: To convert multiple non-RAID to RAID on a
given controller, use omconfig storage controller
action=convertnonraidtoraid command. For more
information, see omconfig Convert Multiple Non-RAID
To RAID.
Example to Convert non-RAID to RAID on physical disk 3 on connector
0 of controller 1. On a SAS controller, the physical disk
resides in enclosure 2.
Example for SAS controllers
omconfig storage pdisk
action=nonraidtoraid controller=1
pdisk=0:2:3
Omconfig Virtual Disk Commands
The following table provides the omconfig command syntax required to execute virtual disk tasks.
CAUTION: The omconfig storage vdisk action=deletevdisk controller=id vdisk=id command deletes a virtual disk.
Deleting a virtual disk destroys all information including file systems and volumes residing on the virtual disk.
Table 89. Omconfig Manage Virtual Disk Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs
omconfig storage vdisk action=checkconsistency controller=id vdisk=id
action=cancelcheckconsistency controller=id vdisk=id
action=pausecheckconsistency controller=id vdisk=id
action=resumecheckconsistency controller=id vdisk=id
action=checkconsistency controller=id vdisk=id
action=blink controller=id vdisk=id
action=unblink controller=id vdisk=id
action=initialize controller=id vdisk=id
action=fastinit controller=id vdisk=id [force=yes]
action=slowinit controller=id vdisk=id [force=yes]
action=cancelinitialize controller=id vdisk=id
action=cancelbginitialize controller=id vdisk=id
action=assigndedicatedhotspare controller=id vdisk=id pdisk=<PDISKID> assign=<yes |
no>
action=deletevdisk controller=id vdisk=id [force=yes]
148