Command Line Interface Guide

Table 82. omreport Fluid Cache Pool Command
Required Command Levels (1, 2, 3) And name=value pair Use
omreport storage fluidcachepool
Displays the properties of the fluid cache pool.
omreport Partition Status
The following table describes the syntax for the omreport partition commands.
Table 83. omreport Partition Command
Required Command Levels (1, 2, 3)
And name=value pair
Optional name=value pairs Use
omreport storage partition
Displays the partition details of the
specified virtual disk.
controller=id vdisk=id, where id is the
controller number and the virtual disk
number. For example: controller=0
vdisk=1.
Displays all the partitions in the
specified virtual disk on the controller.
Omreport Fluid Cache Disk Status
The following table describes the syntax for the omreport fluidcachedisk commands.
Table 84. omreport Fluid Cache Disk Command
Required Command Levels (1, 2, 3) And name=value pair Use
omreport storage fluidcachedisk
Displays the properties of the fluid cache disks.
Omreport Storage Tape
The following table describes the syntax for the omreport storage tape command.
Table 85. Omreport Storage Tape Commands
Required Command Levels (1, 2,
3)
Optional name=value pairs Use
omreport storage tape Display tape drive properties.
controller=id, where id is the controller
number. For example: controller=0.
Displays all tape drives.
connector=id Displays all the tape drives on the
specified connector.
tape=<tape id>, where
tapeid=id=<connector:targetID>
Displays the specified tape drive.
137