Command Line Interface Guide

NOTE: The status of the EMMs is displayed as degraded if there is a mismatch between the EMM firmware.
Table 74. Omreport EMM Commands
Required Command Levels (1, 2, 3) and
name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for all
enclosures attached to the system.
controller=id
enclosure=<ENCLOSUREID>
info=emms where id is the controller
number and ENCLOSUREID is the
enclosure number. For example:
controller=0 enclosure=2
Displays the enclosure management
modules (EMMs) for the specified
enclosure.
controller=id
enclosure=<ENCLOSUREID>
info=emms index=n where id is the
controller number and ENCLOSUREID
is the enclosure number and n is the
number of an EMM. For example:
controller=0 enclosure=2 info=emms
index=1
Displays the specified EMMs.
Omreport Enclosure Slot Occupancy Report
The following table describes the syntax for the omreport Enclosure Slot Occupancy Report commands
Table 75. Omreport Enclosure Slot Occupancy Report Commands
Required Command Levels (1, 2, 3) and
name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for all
enclosures attached to the system.
controller=id
enclosure=<ENCLOSUREID>
info=pdslotreport, where id is the
controller number and ENCLOSUREID
is the enclosure number. For example:
controller=0 enclosure=2
Displays the empty and occupied slot
details for the specified enclosure.
NOTE: This command is not
supported on Blackplane, SCSI,
and SWRAID controllers.
Omreport Battery Status
The following table describes the syntax for the omreport Battery commands
134