Command Line Interface Guide

omconfig servermodule recovery timer=120

Omconfig System Shutdown Or Omconfig Servermodule Shutdown

Use the omconfig system shutdown or omconfig servermodule shutdown command to determine the way in which the

system shuts down. During system shutdown, the default is to shut down the operating system before powering off the

system. Shutting down the operating system first closes down the file system before powering the system down. If you

do not want to shut down the operating system first, use the osfirst=false parameter. The following table displays the

valid parameters for the command.

NOTE: Due to the limitations of certain operating systems (for example, VMware ESXi), certain features are not

available with this release of OpenManage Server Administrator.

Table 50. Valid Parameters Of System Shutdown

name=value pair Description

action=reboot Shuts down the operating system and initiates system startup, performing BIOS checks and

reloading the operating system.

action=poweroff Turns off the electrical power to the system.

action=powercycle Turns off the electrical power to the system, pauses, turns the power on, and reboots the

system. Power cycling is useful when you want to re-initialize system components such as hard

drives.

osfirst=true | false

true: Closes the file system and exits the operating system before shutting down the system.

false: Does not close the file system or shut down the operating system before shutting down

the system.

Example Shutdown Commands

To set the shutdown action to reboot, type:

omconfig system shutdown action=reboot

omconfig servermodule shutdown action=reboot

To bypass operating system shutdown before the system is powered off, type:

omconfig system shutdown action=reboot osfirst=false

omconfig servermodule shutdown action=reboot osfirst=false

Omconfig System Thrmshutdown Or Omconfig Servermodule Thrmshutdown

Use the omconfig system thrmshutdown or omconfig servermodule thrmshutdown command to configure a thermal

shutdown action. You can configure the system for a thermal shutdown when a temperature probe detects a

temperature probe warning or failure event.

The following table displays the valid parameters for the command:

110