Users Guide

IPv4 Address

• IP Address Source

• IP Address

• IP Subnet

• IP Gateway

IPv6 Address

• IP Address Source

• IPv6 Address 1

• Default Gateway

• IPv6 Address 2

• Link Local Address

• DNS Address Source

• Preferred DNS Server

• Alternate DNS Server

NOTE: You can view IPv4 and IPv6 address details only if you enable the IPv4 and IPv6 address properties under

Additional Configuration in the Remote Access tab.

Configuring The Remote Access Device To Use A LAN Connection

To configure the remote access device for communication over a LAN connection:

1. Click the Modular Enclosure → System/Server Module → Main System Chassis/Main System → Remote Access

object.

2. Click the Configuration tab.

3. Click LAN.

The LAN Configuration window appears.

NOTE: BMC/iDRAC management traffic does not function properly if the LAN on motherboard (LOM) is teamed

with any network adapter add-in-cards.

4. Configure the following NIC configuration details:

– Enable NIC (This option is available on Dell PowerEdge x9xx systems when DRAC is installed. Select this

option for NIC teaming. In Dell PowerEdge x9xx systems, you can team NICs for added redundancy.)

NOTE: Your DRAC contains an integrated 10BASE-T/100BASE-T Ethernet NIC and supports TCP/IP. The NIC

has a default address of 192.168.20.1 and a default gateway of 192.168.20.1.

NOTE: If your DRAC is configured to the same IP address as another NIC on the same network, an IP address

conflict occurs. The DRAC stops responding to network commands until the IP address is changed on the

DRAC. The DRAC must be reset even if the IP address conflict is resolved by changing the IP address of the

other NIC.

NOTE: Changing the IP address of the DRAC causes the DRAC to reset. If SNMP polls the DRAC before it

initializes, a temperature warning is logged because the correct temperature is not transmitted until the DRAC

is initialized.

– NIC Selection

NOTE: NIC Selection cannot be configured on modular systems