User's Manual

268 Troubleshooting
A Task Menu Option is Not Displayed
You may notice that the task menus do not always display the same task
options. This is because Storage Management only displays those tasks that
are valid at the time the menu is displayed. Some tasks are only valid for
certain types of objects or at certain times. For example, a Check Consistency
task can only be performed on a redundant virtual disk. Similarly, if a disk is
already offline, the Offline task option is not displayed.
There may be other reasons why a task cannot be run at a certain time. For
example, there may already be a task running on the object that must
complete before additional tasks can be run.
A Corrupt Disk or Drive Message Suggests Running autocheck During a
Reboot
Let autocheck run, but do not worry about the message. The reboot
completes after autocheck is finished. Depending on the size of your system,
this may take about ten minutes.
Erroneous Status and Error Messages after a Windows Hibernation
Activating the Windows hibernation feature may cause Storage Management
to display erroneous status information and error messages. This problem
resolves itself when the Windows operating system recovers from hibernation.
Storage Management May Delay Before Updating Temperature Probe
Status
In order to display the enclosure temperature and temperature probe status,
Storage Management polls the enclosure firmware at regular intervals to
obtain temperature and status information. On some enclosures, there is a
short delay before the enclosure firmware reports the current temperature and
temperature probe status. Because of this delay, Storage Management may
require one or two minutes before displaying the correct temperature and
temperature probe status.