SNMP Reference Guide

Description Line Item Explanation
Chassis intrusion
state: <Intrusion
state>
Specifies the chassis intrusion state (open or closed), for example:
Chassis intrusion state: Open
Chassis location:
<Name of chassis>
Specifies the name of the chassis that generated the message, for example:
Chassis location: Main System Chassis
Configuration error
type: <type of
configuration error>
Specifies the type of configuration error that occurred, for example:
Configuration error type: Revision mismatch
Current sensor value
(in Amps): <Reading>
Specifies the current sensor value in amps, for example:
Current sensor value: 7.853
Date and time of
action: <Date and
time>
Specifies the date and time that an automatic server recovery action was
performed, for example:
Date and time of action: Fri May 30 23:55:44 2003.
Description:
<Description of event>
Specifies the description of the event that occurred, for example:
Description: Chipset Err: Critical Event sensor, front
panel NMI / diagnostic interrupt was asserted.
Device location:
<Location in chassis>
Specifies the location of the device in the specified chassis, for example:
Device location: Mem Card A
Discrete current
state: <State>
Specifies the state of the current sensor, for example:
Discrete current state: Good
Discrete temperature
state: <State>
Specifies the state of the temperature sensor, for example:
Discrete temperature state: Good
Discrete voltage
state: <State>
Specifies the state of the voltage sensor, for example:
Discrete voltage state: Good
Fan sensor value:
<Reading>
Specifies the fan speed in revolutions per minute (RPMs) or On/Off, for example:
Fan sensor value (in RPM): 2600
Fan sensor value: Off
Log type: <Log type>
Specifies the type of hardware log, for example:
Log type: Embedded Server Management (ESM)
Memory device bank
location: <Bank name
in chassis>
Specifies the name of the memory bank in the system that generated the message,
for example:
Memory device bank location: Bank_1
Memory device
location: <Device name
in chassis>
Specifies the location of the memory module in the chassis, for example:
Memory device location: DIMM_A
Number of devices
required for full
redundancy: <Number>
Specifies the number of power supply or cooling devices required to achieve full
redundancy, for example:
Number of devices required for full redundancy: 4
Peak value (in Watts):
<Reading>
Specifies the peak value in Watts, for example:
Peak value (in Watts): 125
530